The Arisaka Finger Stop was developed as a low profile, minimal control accessory. This version is for 1913 Picatinny rails.
The Finger Stop has a slim profile which is ergonomically designed to
be located between your index and middle fingers. This typically places
it further forward on the handguard, which means it doesn't get in the
way when transitioning to kneeling or prone shooting positions, where
most people move their support hand towards the rear. The wider profile
also functions equally well as a rear hand stop, for those who prefer it
in this location.
Additionally, the Finger Stop functions well as a forward limit to
prevent your hand from slipping off shorter handguards onto a hot barrel
or suppressor, and as a barricade rest.
The Finger Stop is secured to the rail by two nylon tipped set
screws. Due to the low profile design, the Finger Stop must be installed
by sliding it onto the 1913 Picatinny rail. The fit is very precise to
the 1913 Picatinny specification, so out-of-spec or damaged rails may
result in difficulties during installation.
Height: 0.75" above 1913 Picatinny rail
Weight: 0.4 oz
The Finger Stop is CNC machined from 6061 aluminum and
MIL-A-8625 Type III hard coat anodized. Requires a 3/32" Allen wrench for installation (not included). Made in the USA.