Home > Hard Gear >

Vltor EMOD Enhanced Carbine Modstock
Vltor Carbine Modstock Enhanced
Vltor Carbine Modstock Enhanced

Alternative Views:

List Price: $114.95
Our Price: $103.46

Product Code: VLT.203



Per ITAR regulations, I understand that SKD cannot ship this item to APOs and International addresses. Note: US Military members serving OCONUS, please have your order shipped to your US address.


Vltor Enhanced Carbine Modstock

The EMOD is based on the same rugged and practical design as the original Vltor Modstock - with specific features designed from lessons taken from the modern battlefield.

The EMOD is about one inch longer than the original Modstock and with the rubber butt plate installed, is about a quarter of an inch longer than the CRANE SCB. The increased length of the EMOD is a major benefit when used on scoped rifles (SPR/DMR), as it increases the available comb for any given length of pull.

The buttplate of the EMOD is slightly wider and longer at the toe than the regular M4 stock with a noticeable negative pitch, making transitions from the ready feel much more natural. The EMOD was given enough weight to help balance out the normally muzzle heavy feel associated with negative pitch buttstocks.

The toe of the buttplate is rolled under; giving the EMOD a superior feel when the weapon is held in the "out of pocket" heads up hold. The buttplate is covered with a removable rubber buttpad that is molded over a metal strike plate. The shape of the buttplate and the rubber buttpad give a solid stock purchase in all situations.

The EMOD features more storage in the removable, waterproof side compartments; the EMOD holds up to four CR123 or three AA batteries. There is also an additional weather proof compartment in the clubfoot area of the stock, this compartment can be accessed quickly and holds two AA batteries or other small parts.

Constructed from the finest materials, the EMOD will stand up to the most rugged demands. The EMOD is available for either the standard "MilSpec" receiver extension tube, or for the aftermarket "Commercial" size tube. Available colors include Black, Foliage Green and Flat Dark Earth (tan). The EMOD is only available in the Clubfoot model.

  • Style: Clubfoot with Butterfly Latch
  • Colors: Black, FDE Tan, Foliage Green
  • Receiver Extension Tube Type: Available for MilSpec or Commercial
  • Length w/buttpad: 7.75 inches (at centerline of tube)
  • Weight: 14oz
  • LOP fully collapsed: 11.5 inches
  • LOP fully extended: 14.75 inches
  • Buttpad angle: -5 degrees with decrease to -15 at toe.
  • Sling Attachments: Standard military and Quick Disconnect Swivel Socket accessible from both sides.
  • Storage: Total of 8ea CR123, or 6ea AA batteries in storage tubes. Additional storage for 2ea AA batteries or small parts in quick access compartment.

Additional Info
Loading nanoRep
Loading nanoRep

5 of 5 Total Reviews: 11 Write a Review

  0 of 0 people found the following review helpful:
Like putting on your favorite pair of jeans! April 26, 2012
Reviewer: Stephen Epps from Gilbert, AZ United States  
The Emod stock is a little heavy but counter balances the gun very well! I have many stocks, but the Emod is my favorite! Vltor has had it right for years, the Emod rocks! Skd once again makes my life easy by being the only place to get your gear! SKD is the BEST! Thanks SKD!

Was this review helpful to you?

  0 of 0 people found the following review helpful:
Tough As Nails, Bad For Facial Hair June 16, 2011
Reviewer: Andy from Minneapolis, MN United States  
The EMOD is my new favorite stock.  It is durable and sturdy, and it was obviously built with survivability in mind.  The amount of carriage space on this stock is staggering.  You can carry up to 8 AA batteries or 8 CR123 lithiums, or a combination of both.  This is a huge advantage, because it allows you to stop carrying extra batteries in your grip and a vertical foregrip, thus reducing the weight on the middle and front of the rifle.  The added weight of the EMOD, combined with the added battery load, helps to make your rifle more butt-heavy.  This weight transfer allows better target transition and controllability due to less swinging mass.
However, be forewarned that the design of the battery compartments do tend to pull facial hair if you have a long beard or goatee.  This can be solved by a simple piece of tape over the gap, however.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
Vltor EMOD stock March 19, 2011
Reviewer: Dave Melvin from Rapid City, SD United States  
Perfect fit on my BCM lower. No slop or play AT ALL. Major improvement over the MagPul MOE that I had. Will definitely use the same on my next build. Shipping/delivery by SKD was outstanding. Had it in just three days.

Was this review helpful to you?

  1 of 1 people found the following review helpful:
Vltor Enhanced Carbine Modstock September 22, 2010
Reviewer: Daniel Hernandez from Eugene, OR United States  
Esthetically pleasing to the eye, but also very functional. All the compartments seem to be water tight. The cheek weld is firm and is a better trade off than the traditional manufacturer's butt-stock. FYI be sure to get the correct sizing (ie milspec or commercial) before ordering.

Overall I would recommend buying this product to anyone who wants and better cheek weld or a mean looking weapon.

Was this review helpful to you?

  0 of 1 people found the following review helpful:
Excellent Stock February 11, 2010
Reviewer: Monty Scherff from Aurora, NE United States  
I've like this stock so much, I have it on two other rifles.  The fit is tight and the cheek weld is right on .  Pleanty of storage for batteries and  small tools.  Highly recommend this stock.

Was this review helpful to you?

View All Customer Reviews